Drogo Smart Phone Stand
Drogo Smart Phone Stand
Published 2017-09-06T16:42:40+00:00
This design is an entry into the Vectary Design Competition sponsored by MakeX
Trying to model a dragon from game of thrones. Ended up with a low(ish) poly tiny dragon. Should be able to hold most smart phone models.
This model was created with VECTARY - the free, online 3D modeling tool
Credits:
This model was printed at 60% scale with 10%infill and 0.3mm layer height. Support is needed. The design intent is to hold the smart phone in between the wings with the foot piece on the tail. The resulting model is quite big but looks good too me :)
This model was printed at 60% scale with 10%infill and 0.3mm layer height. Support is needed. The design intent is to hold the smart phone in between the wings with the foot piece on the tail. The resulting model is quite big but looks good too me :)
发表的日期 | 06/09/2017 |
材料数量 | 87g Including supports |
尺寸大小 | 210 x 211 x 187 at full scale |
打印工艺 | FDM |
复杂程度 | 中级 |