Hand Crank Fan
Hand Crank Fan
Published 2014-08-01T16:41:55+00:00
For those summer days when you're in need of some cooling air! This hand crank fan delivers a consistent flow with a set of gears in a step up ratio which means a simple turn of the crank will result in the fan turning at a much higher rate.
NOTE: The files have been updated to be better, faster and are now Barnacules approved!
Below is the video review done by Barnacules if you want to see how to assemble and get some neat tips for this build. Check out his channel here.
The Model was printed at 0.15mm Resolution. The housing and fan blades should be printed at 15% infill and the rest of the model should be printed at 100% infill. you can use oil to lubricate the gear to get them to run smoother. There is an album of images in the Zip folder with instructions on how to assemble the parts, there is a gif on the page to show quickly how it assembles.
发表的日期 | 01/08/2014 |
让时间去下载 | 450 - 480 分钟 |
材料数量 | 85g |
尺寸大小 | 12.5cm x 22cm x 8cm |
复杂程度 | 中级 |