My turn signal was broken shortly before my motorcycle tour started, so I had to repair this quickly. SelfCAD is slightly different than the programs I am used to, but after a short introduction I finished the design of this part in several minutes. Before I started the designing process, I checked all the functions.

Basically, I just stacked two differently sized cylinders from 3D Shapes to model the outer shell. Then I have created recesses with several cylinders and the function "Difference" from Stitch & Scoop.

I have found all the needed information in this video: https://www.youtube.com/watch?v=jtwgqnXfU3c&t=67s

Designed and uploaded with www.selfcad.com #selfcad #sculp-with-selfcad