1/144 HWF 90mm GM System Weapon
1/144 HWF 90mm GM System Weapon
3D
Published 2024-05-01T17:04:59+00:00
During the development of GM mobile suit, several model of machine guns were designed as a backup to the GM's primary beam weapon with the 90mm GMG-MG79 being one of them. Unfortunately the beam spray gun while powerful has very short practical range, resulting in GM platoons to be outgunned by Zeon adversary until they managed to close the distance. To address this shortcoming and due to its mechanism still functioning in outer space the 90mm MG was chosen as a common platform from which a standard rifle & a support weapon could be further developed. The resulting System Weapon was so modular that a GM could switch its weapon configuration in combat.
This is a 23-parts 3D-printable model that can be used to create GM Rifle, GM Long Rifle, & two variants of GM Machine Gun in 90mm caliber. Most of the parts are interchangeable but each of the barrel type can only be paired with a matching forend. Designed for 1/144 scale gunplas, it can be used by similarly sized action figures. To use with 1/100 scale gunpla upsize the model to 144% and for 1/60 gunpla upsize it to 240% though I'm not sure if it fit the hands of either scale. For human-sized model scaling the GM Rifle up to 1140% should make it similar in length to the FAMAS series and split the model from there.
Dimension : 95mm x 23mm x 6mm
Weight : 3-5 grams
FDM Printer
Resolution : 0.4mm line width x 0.2 layer height maximum, finer resolution preferred
Wall Thickness : ≥ 0.8mm
Infill : 15%
Support : Yes
Printing Time : +60 minutes
MSLA Printer
Resolution : 0.05mm layer height or finer
Orientation : Arctan of layer height used divided by printer XY resolution
Support : Yes
Printing Time : +2 hours
| Date published | 01/05/2024 |
| Benoetigte Zeit | 60 - Minuten |
| Menge an Filament | 3-5 grams |
| Dimensionen | 95mm x 23mm x 6mm |