To print support free: - Print the auger with a 4mm brim with the blades facing straight up - the flat face on the backside should be down - Print the spout upside down with a 3-4mm brim - Print the lid with the handle side up - Print the roller on its side - Print the roller cap with the cap side down - Print the body right side up - Print the handle so the bump on it is facing up To assemble: - Place the auger in the body of the dispenser solid side first - Snap the handle into the auger, making sure to have the bump on it fit into the indentation in the auger (this should secure it in place) - Place the roller onto the handle - Place the roller cap on the end of the handle to secure the roller in place - Fill with coffee grounds or beans - Put the lid in place - Crank clockwise one turn to dispense 2 tablespoons - (optional) To further secure the handle, you can place a piece of 1.75mm filament into the hole and cut to size Note: I ran out of filament printing the body, but all other parts have been printed successfully without support. Pictures will be uploaded soon.