LED Christmas Tree
LED Christmas Tree
Published 2015-12-08T17:48:56+00:00
Here a Small christmass tree with RGB FlashingLED to illuminated your room!
To do this project you will need 24 LEDs, with the correct resistor, a power supply with a female jack, and finaly a small switch. I give you the link of the ones i have used :
Also, you will foudn 3 differents STL files for the tree: One with a raft i designed, you can use this one or the one with raft&support without any "slicer support" if you have a very reliable printer. If you're note sure about your printer, use your slicer support and raft.
- RGB flashing LED: http://www.amazon.co.uk/Alpha-Crucis-Diffused-Slow-Flashing/dp/B008AS4A3M/r
- Resistor : 150 Ohm for 4.5Volt power supply it's find with these LEDs.
- Heat shrink to prevent short cut between the pins of the LED.
- Switch: http://www.maplin.co.uk/p/single-pole-sub-miniature-ff77j
- Power Supply: http://www.maplin.co.uk/p/maplin-6w-switched-mode-acdc-fixed-voltage-45v-power-supply-mg77j
- Female Jack: Use the jack related to the power supply you will use, 8mm maximum (Size of the hole in pot)
I took few pictures during the constrution, i put them here, that could help you.
Making this christmass tree is a little bit long (about 4hours) but very simple !
Have fun to build it ;)
For the 3 LEDs at the top of the tree i have deport the resistors so it's easier to put into the tree
Use a bit of blue tack to hold the LED inside the holes.
0.2mm layer height, medium infill.
Date published | 08/12/2015 |
Benoetigte Zeit | 300 - 700 Minuten |
Menge an Filament | 100g |
Dimensionen | 135*52*52 |
Technologie | FDM |
Schwierigkeitsgrad | Difficult |