Ossum Driveshaft Mk I
Sin soporte
Destacado
13,929
visitas
1,980
descargas
16
colecciones
0 comentarios
Cargando comentarios... 
Ossum Driveshaft Mk I
3D
Published 2018-05-29T07:22:26+00:00
224
0
Add to Collection
Descripción
This is the first iteration driveshaft for my 1:10 RC racer project.
The pivot pins are M2x8 screws (or equivalent).
The sleeve is printed on its narrow edge, so that all the walls are at 45 degrees and no support is needed.
Some sanding of the shaft is likely to be required to ensure smooth action.
Información técnica
| Date published | 29/05/2018 |
| Sin apoyo | YES |
Más información
Archivos
Thank you for the design! Ok, my print not look so good, but I scaled it down 2x for my toy boat and drive shaft still look's functional. Thank you!!!