Temperature Stringing calibration blocks
Temperature Stringing calibration blocks
3D
Published 2018-05-29T11:14:06+00:00
Here is a test print for calibrating your hot-end temperature.
This is to see how your printing temperature influences stringing over spans and blobbing on fine detail.
Inspired by the temperature calibration test shown at:
http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide#stringing
Printed on 0.2mm layer height.
In Repetier host I set the temperature (under "Manual Control") as the printer reached each new section.
You could also manually edit the G-code.
Find the layer on which the temperature should change and insert the "M104 Sxxx" command where "xxx"=the desired temperature
E.g. M104 S230 for 230ºC.
It seems the small overhangs are kinda tricky to get right, I tried increasing the wall thickness setting but still had the first layer of each dangle down.
| Date published | 29/05/2018 |
| Sin apoyo | YES |
