I printed this 3 times. The first time it fell to bits just removing it from the build plate. For the second print I increased the infill density, and reduced the density of the supports, but the head and leg fell off removing the supports. In both cases there were no eyebrows and the pony tail was in two bits, broken half way down. The third print (pictured) was printed using 3 shells and an infill of 20% for strength with reduced density supports. I managed to keep this in one piece, but the eyebrows were only attached by the supports and not touching the face. The pony tail still has a kink half way down where it was breaking before. The mouth is off centre.