Awesome Skull Lamp!
Awesome Skull Lamp!
3D
Published 2016-09-12T10:23:34+00:00
Check out our Etsy: https://www.etsy.com/shop/3DCentral
Light up your room with this awesome skull lamp! This lamp actually plugs into a wall and uses a standard 120V outlet to power the LED bulb inside!
Simply print out both pieces of the skull, flat side down. Glue magnets into the hollow voids, allowing the pieces to snap securely together.
The skull mounts directly onto the base; once again, add some super glue to really get a secure fit.
Use a Woods 160 Lamp to provide a lighting base, and *ONLY USE AN LED BULB* for this lamp. A standard incandescent bulb will give off too much heat, and may damage the printed parts.
That's it! Enjoy your new lamp!
This is a Remix of 'Human skull, anatomically correct and printer friendly **updated with jaw**' :
http://www.thingiverse.com/thing:819046
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
| Date published | 12/09/2016 |
| Technology | FDM |
Great model. Thank you!