Ravensburger Labyrinth figurines - pack of Classic Monsters
Ravensburger Labyrinth figurines - pack of Classic Monsters
Published 2019-08-27T16:29:07+00:00
Pack of four monster figurines for Ravensburger Labyrinth design competition. These creatures of the night are Werewolf, Vampire, Mummy and Zombie.
For best results on FDM printers, print one by one with .1 mm layer height, relatively slow and with high infill and shell count. These things are small and delicate so there is a chance that the hot-end could bend the figure and cause layer shifts or knock it off the build plate completely. To stabilize the figurine, use raft or brim.
These are 100% printable without any supports (even without raft or brim). However, you may use supports to add further stabilization.
SLA/DLP printers should offer best quality prints for these figurines.
Date published | 27/08/2019 |
Time to do | 25 - minutes |
Support Free | YES |