Sarcoise's Print of Joker bust
Community Print Impresión 3D de Joker bust
Published 2018-12-23T01:32:29+00:00
4
1
Impreso con: Creality Ender 3
Material: PLA
Descripción
When I seen this creation I knew I had to make it for a friend of mine as a gift. To avoid failed prints, I tried to duplicate the print techniques the creator used in his print time lapse. It looked to me the only support material used was on his chin, thick outer walls were used to make overhangs easier/more reliable, and infill was rather thick with a grid setting. I tried to block all support from everywhere except his chin, .15 layers, 3 outer walls, 15% fill. All other settings were standard for my printer. I did have a problem getting all support material from generating with the block feature in Cura, but after slicing for hours and changing settings, I decided to run with it. I was able to get a good print in the first go. This is more to do with the design that my skills as it was intended to need support only from the chin, all other layers laid directly on the previous layer, perhaps with high overhang, but that's what the thick walls were for. I did get some support material failed extrusion on his left side that will need to be address in finishing, but otherwise, it looks great.
All in all, a great design. Thanks for allowing me to enjoy printing this!