vpnr's Print of Planetary Phone Stand
655
visitas
1 comentarios
Cargando comentarios... 
Community Print Impresión 3D de Planetary Phone Stand
Published 2021-08-04T17:14:39+00:00
0
1
Descripción
This prints well, all the tolerances are well designed. This is printed on a Wanhao MultiColor PLA, 40% infill, almost a 26 hour print. However the section holding up the circular coupling on Mid Base is weak. at the junction (as in the centre of the picture, the section narrows down too much. This broke when a guest tried to rotate the stand not knowing that the bolt needs to be loosened first. For now, I have super glued it, but maybe the cutout there can be optimised for more strength