GerardFG-3DPrints's Print of The Forgotten One
Community Print Impresión 3D de The Forgotten One
Published 2023-09-14T20:46:40+00:00
2
2
Impreso con: AnyCubic Photon Mono 4K
Material: Resin
Descripción
Printed in Water Wash+ resin by Anycubic, 2 second exposure time, 50 microns layers.
Two simultaneous prints on two Anycubic Photon Mono 4k machines:
1. upper torso = 6h approx.
2. lower torso = 8h 55min
I would just like to highlight that in my impression a band has appeared that crosses diagonally across the bottom of the cape. I would like to resolve this question with you. If you know the causes of the appearance of this type of effects in the impressions, I will listen to you with interest.